Throttle Return Spring
- Simon Moore
- Posts: 4
- Joined: Sun May 07, 2006 12:11 pm
- Location: Staffs / Shropshire border
- Contact:
Throttle Return Spring
My Zetec engined 4/4 runs with the standard Ford injection. Blue Book E12.4.2 specifies a positive method of throttle closing by means of external springs. The standard Ford set up has two springs to close the throttle. Can anone tell me if this is sufficient? Do I need to install a separate spring as well? I am concerned about scruitineering for the Speed Championship. Thanks, Simon
-
- Posts: 216
- Joined: Wed Dec 07, 2005 12:06 am
- Location: Marple, Cheshire
Simon
Don't panic, you are absolutely fine with the set up that you have. This ruling mainly applies to carburettor setups that may only have one spring, all standard injection setups that I have seen always have 2 springs.
If you have any other concerns, drop me a line directly if you wish, otherwise, we look forward to seeing you at an event in the near future.
Simon Baines
Don't panic, you are absolutely fine with the set up that you have. This ruling mainly applies to carburettor setups that may only have one spring, all standard injection setups that I have seen always have 2 springs.
If you have any other concerns, drop me a line directly if you wish, otherwise, we look forward to seeing you at an event in the near future.
Simon Baines
-
- Morgan Class C
- Posts: 1157
- Joined: Mon Feb 07, 2005 11:09 am
- Simon Moore
- Posts: 4
- Joined: Sun May 07, 2006 12:11 pm
- Location: Staffs / Shropshire border
- Contact: